internal flow (pipe) tutorial

I have been following the pipe tutorial with some minor difficulties. When I go to extrude over the path I have created with a sketch I can select my cross section but I cannot select the path. The software seems to be indicating that the path is not a valid choice. I have noticed that the tutorials appear to have been created with a different version.

I ended up building the geometry in segments and then using boolean operations to combine them. Everything else worked fine. I would like to understand what I am doing wrong (or if it is a software issue).

Thanks,
- Matt Bondy<br /><br />Post edited by: Matthew Bondy, at: 2009/01/09 04:44

Confirm here on Salome 3.2.9
I had to build the elbow as a boolean sum of pipes.

Administrator wrote:

The bug is now fixed in Salome-Meca-2009.1 (Salome 4.1) !

OT: Dear Admin,
news about Salome-Meca2009-64bit?

Regards.

Administrator wrote:

From my side, I am trying to compile Aster 9.4 64 bit with Intel Compiler 11 to have the best performance... If it works well, I will try to package this version in the next CAELinux (modified Ubuntu 8.04 64bit) along with Salome-Meca-2009

Thanks for the info. I'm trying to compile Aster with Intel compiler too. For now I was able to install Intel compiler only, but Aster complains about ifor compiler missing (I think I made something wrong installing the compiler). If I will have some good news I will post something.

Have a nice day. Alessandro.