×

Notice

The forum is in read only mode.

blender and salome

  • bounhoure
  • Topic Author
  • Offline
  • New Member
  • New Member
More
17 years 5 months ago #1272 by bounhoure
blender and salome was created by bounhoure
Hi,

I'm wondering how I can interchange data between Blender and Salome, both for preprocessing and postprocessing. I've looked for converters between the different formats available in each software but without success.
Anybody have clues about that ?

Bye,
Olivier
More
16 years 5 months ago #2075 by Kristofor Jensen
Replied by Kristofor Jensen on topic Re:blender and salome
You could use blender to create geometry and then export an iges or stp file to salomemecha ...this functionality is already there...never done it myself but it's such a simple operation I can't imagine it not being possible.

Actually doing the pre-post processing in blender would be a whole lot of coding so I wouldn't expect this anytime soon.
Moderators: catux
Time to create page: 0.117 seconds
Powered by Kunena Forum