×

Notice

The forum is in read only mode.

unit of stp files

  • wwiki
  • Topic Author
  • Offline
  • Junior Member
  • Junior Member
More
14 years 5 months ago #3763 by wwiki
unit of stp files was created by wwiki
Hello ,

I import some stp files in salome 5.1.3 .
Dimensions are in meter and I usually work in millimeter.

What's your habit ?
You convert geometry in mm or do all study in meter.

:woohoo:
More
14 years 5 months ago #3768 by Jake
Replied by Jake on topic Re:unit of stp files
By default, SALOME converts to mm. Check the dimensions in your CAD program.
More
14 years 5 months ago #3773 by Claus
Replied by Claus on topic Re:unit of stp files
wwiki wrote:

Hello ,

I import some stp files in salome 5.1.3 .
Dimensions are in meter and I usually work in millimeter.

What's your habit ?
You convert geometry in mm or do all study in meter.

:woohoo:


I do most of my experiments in [mm] but it really only matters when you start assigning properties and load in the ASTER module, before that, Salome has no units as such.

Code_Aster release : STA11.4 on OpenSUSE 12.3 64 bits - EDF/Intel version
  • wwiki
  • Topic Author
  • Offline
  • Junior Member
  • Junior Member
More
14 years 5 months ago #3775 by wwiki
Replied by wwiki on topic Re:unit of stp files
With older salome , Size of step are in mm.
It doesn't do anything. Attention should just be paid.
Moderators: catux
Time to create page: 0.132 seconds
Powered by Kunena Forum