SalomeMeca (caelinux 2010)
- rui simoes
- Topic Author
- Offline
- Senior Member
-
Less
More
- Posts: 48
- Thank you received: 0
14 years 4 months ago #4428
by rui simoes
SalomeMeca (caelinux 2010) was created by rui simoes
hi all,
i haven't understand how to see the results after solver ends.
as i understand, now the solver generates a rmed, (i can see it in the tree)
i am not able to see the file (*.rmed) in the case directory, neither does postpro start automaticaly... and neither can i load the file from the post pro.
even if i set interactive mode i cant see the status of the solver...
any clues?
greetings
rui
i haven't understand how to see the results after solver ends.
as i understand, now the solver generates a rmed, (i can see it in the tree)
i am not able to see the file (*.rmed) in the case directory, neither does postpro start automaticaly... and neither can i load the file from the post pro.
even if i set interactive mode i cant see the status of the solver...
any clues?
greetings
rui
- Claus
-
- Offline
- Moderator
-
Less
More
- Posts: 670
- Thank you received: 34
14 years 4 months ago #4430
by Claus
Code_Aster release : STA11.4 on OpenSUSE 12.3 64 bits - EDF/Intel version
Replied by Claus on topic Re:SalomeMeca (caelinux 2010)
Check the generated .mess file - your calculations fails for some reason, which is why no .rmed file is created and loaded.
From the sound of it, Aster can't connect to your computer (lack of interactive window)
Regards,
Claus
From the sound of it, Aster can't connect to your computer (lack of interactive window)
Regards,
Claus
Code_Aster release : STA11.4 on OpenSUSE 12.3 64 bits - EDF/Intel version
Moderators: catux
Time to create page: 0.118 seconds