Problem viewing model/geometry
- Darren Nelson
- Topic Author
- Offline
- New Member
-
Less
More
- Posts: 2
- Thank you received: 0
15 years 2 months ago #3502
by Darren Nelson
Problem viewing model/geometry was created by Darren Nelson
When I run Salome, it starts fine. However, when importing geometry, creating new geometry, or even trying to mesh the screen is grey until i wiggle the mouse over it. In the case of importing a model, it is there when I move the cursor over it back and forth, but the viewport goes blank once i move the cursor away. Would this be a graphics driver problem?
- Claus
-
- Offline
- Moderator
-
Less
More
- Posts: 670
- Thank you received: 34
15 years 2 months ago #3504
by Claus
Code_Aster release : STA11.4 on OpenSUSE 12.3 64 bits - EDF/Intel version
Replied by Claus on topic Re:Problem viewing model/geometry
Search the forum here - it is a common problem related to you graphics driver.
/C
/C
Code_Aster release : STA11.4 on OpenSUSE 12.3 64 bits - EDF/Intel version
Moderators: catux
Time to create page: 0.126 seconds