×

Notice

The forum is in read only mode.
  1. Forum
  3. Public Forums
  5. Salomé & Pre-processing
  7. Point On Line Intersections Salome 5.1.3

Point On Line Intersections Salome 5.1.3

More
14 years 2 months ago #5128 by Jung
Point On Line Intersections Salome 5.1.3 was created by Jung
I'm trying to construct a point at the intersection of two lines. I'm using the gui interface. There is no error message but there is no point too. Is this a general problem with this feature?

thanks

Jung
Moderators: catux
  1. Forum
  3. Public Forums
  5. Salomé & Pre-processing
  7. Point On Line Intersections Salome 5.1.3
Time to create page: 0.141 seconds
Powered by Kunena Forum