×

Notice

The forum is in read only mode.

Problems meshing a simple surface

More
13 years 6 months ago #5489 by John
Problems meshing a simple surface was created by John
Hello
I'm trying to mesh a surface to study the boundary layer development of a flat plate (homework). Due to the nature of the problem, I need more mesh resolution near the wall which leads to a non-uniform distribution in one direction.

The problem is that when I try to "sub-mesh" the surface using the edges that conform the surface, I have the following error: "Geometry object is not a subshape of the shape to mesh".:

[img]


Thank You in advance.<br /><br />Post edited by: John, at: 2011/05/08 04:18
Attachments:
Moderators: catux
Time to create page: 0.148 seconds
Powered by Kunena Forum