×

Notice

The forum is in read only mode.

FLOW SURFACE

More
10 years 10 months ago #7350 by ben
FLOW SURFACE was created by ben
Basically my project is checking the feasibility of salome for cfd analysis i just want to find out whether it works for other cfd analysis so i would want help in find the fluid domain of the model i am sending you,its a stp file which will load in salome 7.2,0 , for your convince i am sending a research paper in which this feasibility test was performed for another model ,IF you could find the fluid extraction it would be very HELPFUL
THANKING YOU
BEN GEORGE
More
10 years 10 months ago #7351 by ben
Replied by ben on topic Re: FLOW SURFACE
Manifold_assembly.stp

MeshingToolsForOpenSourceCFD(1).pdf
More
10 years 10 months ago #7352 by ben
Replied by ben on topic Re: FLOW SURFACE
this are two files for that
Manifold_assembly.stp

MeshingToolsForOpenSourceCFD.pdf
More
10 years 10 months ago #7355 by Claus
Replied by Claus on topic Re: FLOW SURFACE
Check you attachments or upload another place :)

/C

Code_Aster release : STA11.4 on OpenSUSE 12.3 64 bits - EDF/Intel version
More
10 years 10 months ago #7356 by ben
Replied by ben on topic Re: FLOW SURFACE
Thank you for your reply
I am not able to send a attachment
Can you send me your mail I'd
Regards
Ben
More
10 years 10 months ago #7360 by Claus
Replied by Claus on topic Re: FLOW SURFACE
You can try sending it to clausandersen81_-at_- g-mail, but I will be abroad for at few days now, so I suggest you also try to find a place to upload it, so others can try to help you.

/C

Code_Aster release : STA11.4 on OpenSUSE 12.3 64 bits - EDF/Intel version
Moderators: catux
Time to create page: 0.132 seconds
Powered by Kunena Forum