FLOW SURFACE
- ben
- Topic Author
- Offline
- New Member
-
Less
More
- Posts: 7
- Thank you received: 0
10 years 10 months ago #7366
by ben
Replied by ben on topic Re: FLOW SURFACE
hello
sir i can you tell me your email id again?
regards
ben
sir i can you tell me your email id again?
regards
ben
- ben
- Topic Author
- Offline
- New Member
-
Less
More
- Posts: 7
- Thank you received: 0
10 years 10 months ago #7369
by ben
Replied by ben on topic FLOW SURFACE CREATION
HEY GUYS
I HAVE BEEN TRYING OUT TO GENERATE THE FLOW SURFACE IN SALOME?ITS PART OF MY MASTERS PROJECT .
I WANT THE GEOMETRY TO BE CLEANED UP AS ITS DONE IN OTHER CAD SOFTWARE IF ANYONE COULD HELP ME OUT IT WOULD BE GREAT .MY PROJECT IS BASED ON THIS RESEARCH PAPER WHICH I AM GOING TO ATTACH
REGARDS
BEN
I HAVE BEEN TRYING OUT TO GENERATE THE FLOW SURFACE IN SALOME?ITS PART OF MY MASTERS PROJECT .
I WANT THE GEOMETRY TO BE CLEANED UP AS ITS DONE IN OTHER CAD SOFTWARE IF ANYONE COULD HELP ME OUT IT WOULD BE GREAT .MY PROJECT IS BASED ON THIS RESEARCH PAPER WHICH I AM GOING TO ATTACH
REGARDS
BEN
- Claus
-
- Offline
- Moderator
-
Less
More
- Posts: 670
- Thank you received: 34
10 years 10 months ago #7370
by Claus
Code_Aster release : STA11.4 on OpenSUSE 12.3 64 bits - EDF/Intel version
Replied by Claus on topic Re: FLOW SURFACE
I have received your files and I have looked at the assembly a bit today, but I have no answer for you yet. I'll reply here when I have.
/C
/C
Code_Aster release : STA11.4 on OpenSUSE 12.3 64 bits - EDF/Intel version
Moderators: catux
Time to create page: 0.113 seconds