Question to Nonlinear Static Syntax
13 years 9 months ago #5747
by kwou
Interest: structural mechanics, solar energy (picture at 'my location' shows too little pv panels)
--
kind regards - kees
Replied by kwou on topic Re:Question to Nonlinear Static Syntax
Hoi Basti
Basti wrote:
having no idea of the real strains is quite tricky in non linear analysis. After entering the plastic area the number of iterations will you up, and will go up substantially in the plastic area. Taking too large steps will probably make the code not converge.
Kind regards - kees<br /><br />Post edited by: Kees Wouters, at: 2011/09/16 20:03
Basti wrote:
Hi Kees,
I dont realy expect a concrete value of displacement. I just take the same value of pressure from an other calculation I have done before.
I dont really think about the dimensons of E-Modul and pressuremy focus was the syntax, to get calculation able to run.
I will try it out with lower pressure.
having no idea of the real strains is quite tricky in non linear analysis. After entering the plastic area the number of iterations will you up, and will go up substantially in the plastic area. Taking too large steps will probably make the code not converge.
Kind regards - kees<br /><br />Post edited by: Kees Wouters, at: 2011/09/16 20:03
Interest: structural mechanics, solar energy (picture at 'my location' shows too little pv panels)
--
kind regards - kees
Moderators: catux
Time to create page: 0.240 seconds