Hey, problem with STAT_NON_LINE

Hey Richard,

I'm using the in-built module of Aster in Salome-Meca 2012.2. I made the correction for PROJ, attaching the message file.

Regds,
d_riel

Ok, so you changed back to METHODE='COLLOCATION',
which is not valid for projecting fields at gauss points. The only method for this is ECLA_PG.
You have to change back to that.
Did you create your command file with EFICAS?

I have no clue why ECLA_PG shouldn't be recognized as a valid option for METHODE...

Best regards,
Richard

Hey,

Yes, "COLLOCATION" was an error on my part, I am sorry about that. And I made the command file through EFICAS, where ECLA_PG is a valid option. It does seem strange why ECLA_PG and PROL_ZERO are not recognized .

Is there any work around for this that I could use?

Regards,
d_riel

Hello d_riel,
perhaps there's a problem with your installation.
Could you try another Code-Aster version, or rebuild SalomeMeca?

Best regards,
Richard

hmm ok, ill try doing that.

Regds,
d_riel

Hey,

So I've finally managed to run the file in a newer version of Code Aster. However, I'm getting <EXCEPTION> <DVP_1> with PROJ_CHAMP. Can someone please tell me where I'm making the mistake?

Attaching the .med, .comm and .mess files.

Regds,
d_riel